Electrolux Professional myPRO TE1120HP Heat Pump Tumble Dryer: 8kg, A++, 13A Plug
At a Glance
- Size: H850 x W600 x D630mm, 49kg, freestanding front loader
- Power: 900W, fitted 13A plug
- Capacity: 8kg load, 120 Ltr drum
- Temperature: Up to 55°C
- Warranty: 2 years full manufacturer’s parts and labour warranty
The Electrolux Professional myPRO TE1120HP is a commercial heat pump tumble dryer for hotels, care homes and restaurants that wash on site. It takes an 8kg load in a 120 Ltr drum, dries a full load in around 129 minutes and carries an A++ energy rating.
Installation and Connection
The dryer is fitted with a 13A UK plug and rated at 900W, so it needs no hardwiring. Condensed water goes to a condensed water tank or to a direct drain. It measures H850 x W600 x D630mm and weighs 49kg, and the front and top are stainless steel.
Day-to-Day Use and Cleaning
There are 16 professional programmes, including eco and automatic settings. Professional Residual Moisture Control monitors the load in real time to shorten cycles and avoid over-drying, with drying temperatures up to 55°C. A double-filter system protects the heat pump components, and the maximum noise level is below 70dB.
FAQs
Does it need hardwiring?
No. It is fitted with a 13A plug and rated at 900W.
Does it need a drain?
No. Water can collect in the condensed water tank, or you can connect it to a direct drain.
What does the warranty cover?
It comes with a 2 years full manufacturer’s parts and labour warranty.








Question from Barry Truman: Asked on 18/07/2026 Does it have its own water tank
Hi Barry,The Electrolux Professional myPRO TE1120HP heat pump tumble dryer has its own built-in water tank, which collects the condensed water and can be emptied manually. It can also be connected to a drain for automatic water removal if preferred.Thanks!
Question from Phil Kennerley: Asked on 15/06/2026 does the dryer need an exterior wall vent or is it self contained
Hi, According to Electrolux Professional’s official installation instructions, the TE1120HP is a fully ventless heat pump tumble dryer. It does not require or support external wall venting, as moisture is condensed internally and either collected in the water tank or removed via an optional drain connection.
Thank you.
Question from Amber: Asked on 30/04/2026 We are hoping to purchase this dryer for our hair salon , it will be located in a staff room with a closed door , a few members of staff have asked how much does the dryer heat up the room and is this safe in a small room.
kind Regards.
Hi, The Electrolux TE1120HP heat pump dryer is designed for indoor use with minimal heat emission. It is safe to use in a small staff room, as the heat pump recirculates air internally and prevents overheating. You may notice a slight warming of the room during use, but it is well within safe limits.
Thank you.
Question from Amber: Asked on 27/04/2026 good Afternoon,
am i right in thinking this dryer has the option for drainage but also collects water in a tank we can empty?
Kind Regards.
Hi, The Electrolux Professional TE1120HP is a heat pump condenser tumble dryer that collects water in an internal tank which must be emptied manually after use. It can also be installed with an optional drain connection kit to allow automatic discharge to a waste pipe instead of using the tank.
Thank you.
Question from Lucy: Asked on 13/02/2026 Is this vented to the Right as your looking at the front?
Hi, The Electrolux myPRO TE1120HP is a vent-free heat pump dryer. It does not have a right-side or external exhaust. The dryer recirculates warm air internally and removes moisture by collecting it in a water tank or via an optional drain connection. No external venting is required or possible.
Thank you.